OLM's S209 Style unpaint fender flares will give your vehicle that Japanese aftermarket look you've been looking for. ABS goodness that is pre-painted and ready to go. No pun intended, but these will make your vehicle stick out in a crowd. Matched with subtle mods, you can make a pretty tasteful car. However, this is a really good mod for those who want to go all out as well. Add a big wing, body kit, etc and you can be at the top of the pack in the mods department. Each fender is approximately 3cm (1.18") wide. Since they mount on your existing fenders the overall width increase is around 1.7" front and rear. Unpainted means you can paint match or hydro dip to fit your style.
- Designed to replicate the exclusive S209 model
- Durable ABS construction
- Each fender is approximately 3cm (1.18") wide
- Because these will mount on your existing fenders, the overall width will increase to 1.7" to both front and rear
- Installs using the provided automotive-grade 3M double-sided adhesive
- The result is an exclusive, race-inspired look
- If you have rolled your fenders prior to installation, this kit may not fit flush and properly
- This kit is based on 3D scans and will contour the factory paneling
- REQUIRES THE 2018-2021 FRONT BUMPER
- 12 Pieces (Front and Back) see images
This kit is prepared for those with mild or wild setups. For milder builds, you can simply prep the painted surface of your vehicle with isopropyl alcohol. Of course, that's after giving your vehicle a good bath. Test fit each piece so you can understand how each one aligns with your vehicle and other pieces. Clean the back side of each piece with isopropyl alcohol as well and then apply the included 3M. Remember that 3M applies best when the tape and parts in play are at around 70 degrees. Don't try this installation in the cold. No need to roll your fenders or do any other modifications.
2015-2021 WRX (Requires 2018-2021 Front Bumper)
2015-2021 STI (Requires 2018-2021 Front Bumper)